Outlet and Switch Repair, Houston

Outlet and switch repair in Houston is a common fix that should not be a DIY. A dead outlet or loose switch can mean a loose wire behind the wall. We find the cause, repair or replace it and test the whole circuit.

Signs an outlet or switch needs work

  • An outlet that does not work
  • A plug that falls out or feels loose
  • A switch that clicks but does nothing
  • A GFCI that will not reset
  • Discolored or hot cover plates
  • Buzzing or crackling in the wall
  • Two-prong outlets in an older room
  • You want USB or tamper-resistant outlets for kids

How an outlet visit works

  1. 1Test the circuitWe test power, ground and polarity, and check for a tripped GFCI upstream.
  2. 2Find the causeA dead outlet is often a loose wire, a failed GFCI or a bad connection.
  3. 3Price in writingYou see the price per device before we start.
  4. 4Repair or replaceWe swap the device, replace worn wire ends and add GFCI protection where needed.
  5. 5Test and labelWe test each device and tell you what else we noticed.

Outlet and switch options and costs in Houston

Replace one outlet or switch$100–$250 (typical)

New device, test and cleanup.

GFCI or AFCI outlet$120–$300 (typical)

Shock protection for kitchens, baths, garages and outdoors.

Add a new outlet$200–$600 (typical)

Depends on access and how far the wire runs.

Upgrade two-prong to grounded$200–$800 per circuit (typical)

May require rewiring or GFCI protection.

Typical Houston ranges for planning. Your written price comes after we see the job.

What changes the price

  • Number of devices in one visit
  • Access through walls or attic
  • Type of device, like USB, smart or dimmer
  • Whether wiring is aluminum or very old
  • Whether a permit is needed

See the full cost guide →

Good to know in Houston

Houston’s humidity corrodes outlets in garages and outdoor boxes, so we use weather-resistant covers and GFCI protection outside. After flooding or a roof leak, outlets can be wet inside the wall and look fine. Have them checked before you use them.

Outlet work for hire must be done by a TDLR-licensed electrician. Kitchens, baths, garages and exteriors need GFCI protection under code.

Questions about outlets and switches

Why does my GFCI keep tripping?

Moisture, a worn device or a ground fault on the circuit can cause it. An electrician can find which one.

Can I replace an outlet myself?

Homeowners may do some work on their own home, but wiring errors cause fires. We suggest a licensed electrician.

Do you install USB outlets?

Yes. They are a good fit for kitchens, bedrooms and offices.

Is a loose outlet dangerous?

It can be. Loose connections create heat. Fix them early.

Related